After the cutting edge/edges are selected, you must select each object to be trimmed. These edges can be lines, polylines, circles, arcs, ellipses, rays, splines, text, blocks, xlines or even viewports. On invoking the Trim tool, you will be prompted to select the cutting edges. In such cases, you can use the Trim tool. When creating a design, you may need to remove the unwanted and extending edge. Specify next point or : specify the endpoint of the second polyline segment or press ENTER to exit the command. Specify next point or : specify the endpoint of the first polyline segment. Specify start point: specify the starting point or enter its coordinates After invoking the PLINE command and specifying the start point, the following prompt is displayed: To draw a polyline, you need to invoke the PLINE command. You can draw rectangles by specifying two opposite corners of the rectangle, specifying the area and the size of one of the sides, or specifying the rectangle’s dimensions. You can draw a circle by using six different tools, i.e., by specifying center and radius, by specifying center and diameter, by specifying two diametrical ends, by specifying three points on a circle, tangent to two objects, tangent to three objects. CircleĪ circle is drawn by using the CIRCLE command. You can terminate the LINE command by pressing ENTER, ESC or SPACEBAR. You will have to specify the starting point of the line by clicking the mouse then you will be prompted to specify the second point. You can invoke the LINE command by choosing the LINE tool from the Draw panel, or you can also invoke the LINE tool by entering LINE or L at the Command Prompt. 3D animation, modelling, simulation, game development & others 1.